The Mini Meltdown Machine

Step 1: Waxing Preparation
Remove lid of the wax heater and pour a small amount of wax into the silicone pot.

Step 2: Heat the Wax:
Connect the USB cord to a power source and the device will start heating
automatically (indicated by a red light).
In about 15 minutes, the light will turn green. This indicates it is ready to use.
Stir the wax using a wax applicator. Perform a small patch test on the inner wrist to
check the temperature and make sure it is not too hot.

Step 3: Wax Removal
Apply the wax to the area with unwanted hair in the direction of hair growth. Paint an
even layer of wax that is not too thick and wait for several seconds for the wax to
harden. Hold the skin taut with one hand and quickly remove the wax in the opposite
direction of hair growth using the other hand. Repeat above steps as needed.

Step 4: Storage
After use, unplug the USB from power source and allow device to cool down. Clear the
residual wax from the silicone pot before storage.

Warmer Tips
For best performance, use with adapter plug rated at 5V, 2A or higher. If the current is
below 1.5A, the wax melting time may be extended.
When the heater indicator turns green and a small amount of wax is not fully melted,
this is normal. Stir wax with a wooden applicator before use.